Network Card; Figure 8-39 Installing The Network Card In The Printer - Tektronix Phaser 340 Service Manual

Network card

1.
Power down the printer. Leave the power cord plugged in to provide
a ground path for static discharges. Remove the interface cable.
2. Loosen the two securing screws holding the Phaser Share network
card and remove it.
3. Slide in the replacement network card and tighten the two thumb
screws.
4. Swap the socketed NVRAM chip on the new network card with the
old card so that the printer's network parameters are retained.

Figure 8-39 Installing the network card in the printer

5.
Reconnect the interface cables. Turn on the printer and print the
configuration page; it lists information regarding the Ethernet
interface.
6. Affix the Ethernet address label to the underside of the top cover
where it can easily be accessed.
Field Replaceable Unit Disassembly/Assembly
0
3 4
E R k
D is
A S S I
P H S C
e
rv ic
S e ly
O n
rd
C a
a rt
S m
Network card
Service Manual
8
n d
c o
S e
e r
e d
F e
2 t
s e
R e
1 e
rv ic
S e
e l
ra ll
P a
NV RAM
chip
e t®
e rn
E th
9100-65
8-63