8
Field Replaceable Unit Disassembly/Assembly
Lower feed roller and feed roller magnetic clutch
Feed roller
drive belt
E-ring
Figure 8-27 Removing the feed roller
8-46
Phaser 340 Color Printer
Tools required
Magnetic screwdriver
T-15 TORX tip
1.
Turn off the printer and remove the power cord.
2.
Remove the right-side and left-side covers as explained in the earlier
topic, "Cabinet panels and covers" on page 8-4. Open the front cover.
3.
Remove the maintenance tray.
4.
Disconnect the wiring harness from the clutch leading to I/O board 1.
5.
Remove the E-ring securing each end of feed roller shaft. Remove the
feed roller magnetic clutch.
6.
Remove the feed roller drive belt and feed roller pulley. Remove the
feed roller bushings. Remove the feed roller.
Bushing
Feed roller
pulley
Feed roller
clutch
T-20 TORX tip
I/O board 1
E-ring
Bushing
Feed
roller
9100-56