Resetting Nvram; Phaser 740 Printer; Phaser 750 Printer - Tektronix Phaser 740 Service Manual

Resetting NVRAM returns all the image processor's NVRAM-stored parameters,
including the network card, to their factory defaults except the print counts and the
Adobe firmware serial number.

Phaser 740 printer

To reset the image processor to its factory default values, follow this procedure:
1. Turn the printer off.
2. Press and hold the front panel Buttons 1 (Exit) and 4.
3. Turn the printer on.
4. When the front panel displays the message "Password?", release Buttons 1
and 4.
5.
Within 10 seconds, press Buttons 1 (Exit) and 3 at the same time. The
NVRAM parameters will be reset to their factory default values. If you do
not press buttons 1 and 3 in the allotted time, the NVRAM will not be
changed.

Phaser 750 printer

Resetting NVRAM returns all the image processor's NVRAM-stored parameters,
except the network parameters, to their factory defaults except the print counts and
the Adobe firmware serial number.
To reset the image processor to its factory default values, follow this procedure:
1. Press the front panel Help button.
2. Scroll to the menu item Printer Administration and press Menu.
3. Scroll to the menu item Reset NVRAM and press Reset.
Alternately, you can follow this procedure to reset all NVRAM parameters, including
network parameters:
1.
Turn the printer off.
2.
Press and hold the front panel Buttons 1 (Exit) and 4.
3.
Turn the printer on.
4.
When the front panel displays the message "Password?", release Buttons 1
and 4.
5.
Within 10 seconds, press Buttons 1 (Exit) and 3 at the same time. The
NVRAM parameters will be reset to their factory default values. If you do
not press buttons 1 and 3 in the allotted time, the NVRAM will not be
changed.

Resetting NVRAM

Service Guide
91