Adjustment Of Height Of Adf - Muratec MFX-2500 Field Engineering Manual

5.3.13 Adjustment of height of ADF

Adjust the height of the ADF (the clearance of the document pass) to pass the document properly.
1. Confirm that the tabs under the platen cover assembly (see the illustration below) touch the contact
glass when the platen cover is closed. If not, adjust the height of ADF by following procedure.
2. Remove the platen top cover. (See page 5-25.)
3. Loosen the nut on the hinges R and L, and turn the hexagon socket set screw to adjust the height of the
ADF and the skew of the platen cover assembly.
If turn the hexagon socket set screw counter-clockwise, the front side will be up and rear side will be
down.
If turn the hexagon socket set screw clockwise, the front side will be down and rear side will be up.
Note: Make sure to tighten the nuts after this adjustment.
Note: If this adjustment for the height of the ADF is not enough, it can cause the skew or the image
deformation.
5-94