Muratec MFX-2500 Field Engineering Manual page 392

Options
6.5.1.6.7 Edge Guides and Trailing Edge Stop
The Trailing Edge Stop is screwed into position (not used for Letter crosswise).
Edge Guides can be slid into any desired position.
Whenever the positions of the Edge Guides and Trailing Edge Stop have been changed, be sure to
perform the paper size setting procedure. (See "Paper Size Setting" that follows.)
* The inch area LCC can be set for Letter crosswise only.
6.5.1.6.8 Paper Size Setting
The paper sizes that can be set are A4 crosswise, B5 crosswise, and Letter crosswise.
After the positions of the Edge Guides and Trailing Edge Stop have been changed, place the DIP switch
keys on LCC Main Board PWB-A in the corresponding positions according to the current paper size.
SW1
ON
OFF
1 2 3 4
SW1
1
2
3
4
Edge guides
Letter Crosswise
OFF
OFF
OFF
OFF
6-38
Trailing edge stops
PWB-A
A4 Crosswise B5 Crosswise
ON
OFF
OFF
OFF
Large Capacity Cassette
OFF
ON
OFF
OFF