Muratec MFX-2500 Field Engineering Manual page 179

Unique Switch d:2 - Modem
Initial
Switch
Setting
7 1 V8 handshake in feeder Tx
0: No
1: Yes
6 0 Factory use only
5 0 Factory use only
4 1 Factory use only
3 0 Factory use only
2 1 ANSam output time
0: 3 sec
1: 4 sec
1 0 Factory use only
0 1 Factory use only
Unique Switch d:3
Unique Switch d:7 - Modem
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 The delay before post-
message is transmitted
3 0
2 0 Factory use only
1 0 Factory use only
0 0 Factory use only
Unique Switch d:8
Adjust
Determine if the handshaking will be done with V.8
recommendation in feeder transmission.
The time limit to output the ANSam (A sinewave
signal at 2100 Hz amplitude-modulated). Sets to "1"
when the V.8 handshake is hard to achieve.
d:6 --- Factory use only
Adjust
If retraining occurs due to the low reception signal
level and few delay of the telephone line, it may
overlap the second post-message. In this case,
increase the delay before the post-message is
transmitted.
Switch 4:
Switch 3:
d:9 --- Factory use only
3-108
Usage/Comments
Usage/Comments
0 ms 100 ms 200 ms
0 0 1
0 1 0
300 ms
1
1