Muratec MFX-2500 Field Engineering Manual page 388

Options
E. When a Paper Take-Up signal is received from the machine, the Separator/Feed Rolls and Paper Take-
Up Roll 1 are driven to transport the paper up to Registration Sensor RSEN. After RSEN has been
blocked, the paper is transported a little further to reach the Vertical Transport Roller, plus form a
registration loop, before being brought to a stop.
F. The Vertical Transport Roller is driven to transport the paper to the machine. When the trailing edge of
the paper being transported by the Vertical Transport Roller unblocks Paper Empty Sensor 1 PPS1,
Paper Take-Up Roll 1 and 2 are driven to transport the subsequent sheet of paper to a position at which
PPS1 is blocked.
Paper empty sensor 1
PPS1
Lift 2
G.A given period of time after the trailing edge of the preceding sheet of paper has unblocked LCC Take-
Up Sensor PPS0, the subsequent sheet of paper located at PPS1 is transported to the standby position.
LCC then waits for the next Paper Take-Up signal to be received.
If no paper is present at the point at which the trailing edge of the preceding sheet of paper is supposed
to block S1 when the subsequent sheet of paper blocks PPS1, the subsequent sheet of paper is
transported to the standby position without being stopped and the LCC waits for the next Paper Take-
Up signal.
Paper empty sensor 1
PPS1
Lift 2
Registration sensor RSEN
Paper standby position
sensor S1
Lift 1
Registration sensor RSEN
Paper standby position
sensor S1
Lift 1
6-34
Large Capacity Cassette
Vertical transport roller
Separator/Feed
roll
Vertical transport roller
Separator/Feed
roll