Muratec MFX-2500 Field Engineering Manual page 160

Memory Switch E:0 - Scanner
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Factory use only
2 1 Factory use only
1 0 Factory use only
0 1 Document TX length limit
0: 3.6 meters
1: 1 meter
Memory Switch E:1
Memory Switch G:0 - Remote reception
Initial
Switch
Setting
7 0 Factory use only
6 1 CML relay off time after
dialing
0: 1 sec
1: 200 ms
5 0 DTMF tones heard through
handset
0: No
1: Yes
4 0 Factory use only
3 0 Factory use only
2 0 Switch to fax upon TAD
disconnect
0: No
1: Yes
1 0 Remote reception from the
second phone
0: No
1: Yes
0 0 Remote reception from fax
handset
0: No
1: Yes
Adjust
Setting to unlimited will override document jam
sensing.
F:9 --- Factory use only
Adjust
When dialing from the keypad, phone line noise
may occur as the CML relay switches on and off.
Set this switch to "0" to avoid this.
Determines if DTMF tones are produced through
the handset in off-hook dialing.
In Ans/Fax Ready mode, if this switch is set to "1",
the machine will switch to fax when any device
connected to the external telephone jack, such as a
second phone or TAD, hangs up.
Ability to perform remote reception (hook-flash
transfer) from the second phone.
Ability to perform remote reception (hook-flash
transfer) from the fax handset.
3-89
Usage/Comments
Usage/Comments