Muratec MFX-2500 Field Engineering Manual page 180

Unique Switch e:0 - Scanner
Initial
Switch
Setting
7 0 Factory use only
6 1 Transmit a small document at
center
0: No
1: Yes
5 0 Scanning standard point of
ADF
0: Front left
1: Rear left
4 0 Factory use only
3 0 Factory use only
2 0 Factory use only
1 0 Factory use only
0 1 Hyper fine resolution
0: No
1: Yes
Unique Switch e:1
Initial
Switch
Setting
7 1 Set the fixed ratio for copy
and the auto ratio in detail
0: No
1: Yes
6 1 Factory use only
5 0 Factory use only
4 0 Factory use only
3 1 Factory use only
2 0 Rotate B5
store it as B5
0: Not rotate
1: Rotate
1 0 Rotate A5
store it as A5
0: Not rotate
1: Rotate
0 1
Rotate A4
store it as A4
0: Not rotate
1: Rotate
Unique Switch e:2
Adjust
When set to "1", the image will transmit at center
even when you put the small document along the
edge.
When set to "0", the document is scanned from the
front left point and the rear part can be missed in
the case that the image is larger than the recording
paper.
When set to "1", the front part can be missed.
When set to "1", Super fine resolution (203 dpi
392 lpi) changes into Hyper fine resolution (406 dpi
392 lpi).
Adjust
When set to "1", the ratio will be calculated in detail
automatically according to the document size and
the recording paper size.
document and This is available when the rotate transmission is set
to ON.
document and This is available when the rotate transmission is set
to ON.
This is available when the rotate transmission is set
document and
to ON.
e:5 --- Factory use only
3-109
Usage/Comments
Usage/Comments