Muratec MFX-2500 Field Engineering Manual page 394

Options
When LCC is Slid in:
During a Copy Cycle:
Both Lift 1 and 2 perform these sequences of operations to keep a given pressure between the paper and
Paper Take-Up Roll.
1. Lift 1 and 2 Ascent Conditions
• The LCC is slid into position.
• The Lift-Up Sensor is unblocked while a paper take-up sequence is being carried out with paper present
on the Lift.
2. Lift 1 and 2 Stop Conditions
• The Lift-Up Sensor is blocked.
• The Lift-Up Sensor is blocked while the paper stack top level position is being corrected.
LCC Set Sensor FRONT is blocked.
LCC Lift-Up Motor EMOT turns forward to raise Lift 1.
The paper stack causes the light blocking plate of the Paper
Take-Up Roll 1 Assy to block Lift-Up Sensor 1 LS1.
EMOT is deenergized and then energized to start turning
backward, thereby raising Lift 2.
The paper stack causes the light blocking plate of the Paper
Take-Up Roll 2 Assy to block Lift-Up Sensor 2 LS2.
EMOT is deenergized.
Paper is consumed as copy cycles are run.
The Paper Take-Up Roll gradually lowers, unblocking the
Lift-Up Sensor.
EMOT is energized and the Lift is raised. This lifts the paper
stack to block the Lift-Up Sensor.
6-40
Large Capacity Cassette