Muratec MFX-2500 Field Engineering Manual page 170

Output attenuation when individual autodialer attributes are set.
Switch -15 -14 -13
dB dB dB
3 1 1
2 1 1
1 1 1
0 1 0
Attribute 3 - Individual Autodialer Setting
Initial
Switch
Setting
7 0 Data signaling rate (DCS)
0: V.17
1: V.33
6 0 Forced received print when
transmitting from memory
0: No
1: Yes
5 0 Changing the date format of
the transmitted TTI
0: No
1: Yes
4 1 TTI transmit
0: No
1: Yes
3 0 ECM response time
0: 3 sec
1: 4.8 sec
2 0 ECM error retransmit time
0: 200 ms
1: 400 ms
1 0 Interval between DIS and DCS
0 0
Switch 1
Switch 0
Attribute 4 - Individual Autodialer Setting
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Retransmit automatically
when receiving RTN/PIN
signals
0: Yes
1: No
2 1 Factory use only
1 0 Factory use only
0 0 Factory use only
-12 -11 -10 -9
dB dB dB dB
1 1 1 1 1
1 1 0 0 0
0 0 1 1 0
1 0 1 0 1
Adjust
0 ms 500 ms 1000 ms 1500 ms
0 0 1
0 1 0
Adjust
3-99
-8 -7 -6 -5
dB dB dB dB
1 0 0 0
0 1 1 1
0 1 1 0
0 1 0 1
(Equivalent to Memory Switch B:2)
Usage/Comments
Determines communication protocol.
Will force a remote Muratec machine with memory
receive capabilities to print directly. This switch will
prevent a memory overflow error at the remote unit.
When set to "1", the machine changes the date
format of the transmitted TTI from MM:DD:YY, or
vice versa.
When set at "0", transmission of the TTI is disabled.
(Note: Turning TTI transmission off may violate
local or federal regulations.)
The time limit to receive the response signal for the
ECM post message.
The time limit before the ECM error is
retransmitted.
1
1
(Equivalent to Memory Switch B:3)
Usage/Comments
When set to "1", retransmission disables
automatically if receiving RTN/PIN signals.
-4 -3 -2 -1 -0
dB dB dB dB dB
0 0 0 0 0
1 0 0 0 0
0 1 1 0 0
0 1 0 1 0