Options Parameter Lists - Omron SYSDRIVE 3G3FV User Manual

Parameter Lists
Para Para Name
meter meter
Display
No. No.
name
E5-03 Motor 2 Sets the motor constants of
motor 2, when used for
no-load
current two-motor switching
Note 1: Enabled when the mo- Note 1: Enabled when the mo-
No-Load
Current
E5-04 Motor 2
Note 2: Set like E1-04 to E2-06.
number of
Note 3: Changes motors after
motor poles
Note 4: Waits to change motor
Number of
Poles
Note 5: Cannot use motor 1
E5-05
Motor 2
phase-to-
phase re-
sistance
Note 6: Motor selection signal Note 6: Motor selection signal
Term
Resistance
E5-06
Motor 2
leakage
Note 7: If the control method for
inductance
Leak
Inductance
Note 1. These voltages are for the 200-V class; Double the voltage for 400-V class Inverters.
Note 2. The default values are restored if the control mode is changed. The defaults for open-loop
control are shown.
Note 3. The default setting depends on the Inverter's capacity. The default settings shown in the table
are for 200-V class, 0.4 to 1.5 kW Inverters.
Note 4. The setting range is 10% to 200% of the Inverter's rated output current. (The default settings
shown in the table are for 200-V class, 0.4-kW Inverters.)
Note 5. The setting range is between 0.00 and 0.1 less than the motor's rated current. (The default
settings shown in the table are for 200-V class, 0.4-kW Inverters.)

7-2-5 Options Parameter Lists

H PG Option Setup: F1
Name
Para
meter meter
Display
No.
name
F1-01 Sets the number of PG (pulse
Number of
PG pulses g generator or encoder) pulses.
Note: Sets the number of pulses
PG
Pulses/Rev
Description Description Setting Setting
0.00 to
2.90
(see
note 5) note 5)
tor 2 selection function
is set for multi-function
input.
2 to 48
Inverter and motor stop.
for 20 to 50 ms after
Inverter input.
0.000
parameters and motor 2
to
parameters at same
65.000
time.
will be enabled when
the motor 2 selected
function is set for multi- function is set for multi
function output.
0.0 to
40.0
motor 1 is different from
that for motor 2, all oth- that for motor 2, all oth-
er parameters of motor
2 will be set to default
settings.
Description Setting
0 to
) 60000
per motor revolution.
Default Default Changes Changes
range range setting setting during during
opera- opera-
tion tion
1.20 NO
(see
note 3)
4 NO
9.842 NO
(see
note 3)
18.2 NO
(see
note 3)
Default Chan-
range range setting setting ges ges
during
opera-
tion
1000 NO
Chapter 7
Control mode
V/f V/f with Open
control PG loop
vector
A A A
A A A
A A A
A A A
Control mode
V/f V/f Open
control with loop
PG vector
X Q X
Flux vec-
tor
A
A
A
A
Page
Flux
vector
Q 5-29,
5-46
7-29