Omron SYSDRIVE 3G3FV User Manual page 340

Parameter Lists
Para Para Name
meter meter
Display
No. No.
name
o1-02 Sets the monitor item to be
Monitor
selection displayed when the power is
turned on.
after
power-on
1: Frequency reference
2: Output frequency 2: Out ut frequency
Power-On 3: Output current
Monitor
4: The monitor item set for
o1-01
o1-03 Frequency Sets the units that will be set
and displayed for the
reference
setting and frequency reference and
frequency monitor.
display
units 0: 0.01-Hz units
1: 0.01% units (Maximum
2 to 39: r/min units (Sets the
40 to 39999: User desired
Set the desired values for
Display
Scaling
Example: When the max. fre-
quency value is 200.0, set
12000
o1-04 V/f pattern Set the V/f pattern setting units.
setting (E1-04, 06, 09 set units)
0: Hz units
units
1: r/min units 1: r/min units
Display
Note: Effective only in the flux
Units
o1-05 o 05 Do not set. o o se
Not used
Address
Display
H Key Selections: o2
Name
Para
meter meter
Display
No.
name
o2-01 Sets the Digital Operator
Local/Re-
mote Key Local/Remote Key
enabled/disabled.
0: Disabled 0: Disabled
Local/Re-
1: Enabled (Switches between
mote Key
the Digital Operator and the
parameter settings.)
7-52
Description Description
frequency is 100%)
motor poles. Cannot
be set in Flex Vector
Control.)
display
setting and
display for the
max. frequency. max. frequency.
Set four digits
without the dec-
imal point
Set the position
of the decimal
point in the first
digit.
control vector mode.
Description
Set- Set- De- De- Chan- Chan-
ting ting fault fault ges ges
range range setting setting during during
opera- opera-
tion tion
1 to 4 1 OK
0 to 0 NO
39999
0, 1 0 NO
--- 0 0 ---
Setting Default Chan-
range range setting setting ges ges
during
opera-
tion
0, 1 1 NO
Chapter 7
Control mode
V/f V/f Open
con- with loop
trol PG vector
B B B
B B B
X X X
--- --- ---
Control mode
V/f V/f Open
control with loop
PG vector
B B B
Page Page
Flux
vector
B 6-111
B 5-9
B 6-31
--- ---
Page
Flux
vector
B 6-112