Omron SYSDRIVE 3G3FV User Manual page 314

Parameter Lists
Para Para Name
meter meter
Display
No. No.
name
E1-11 Used to set the middle
Mid. Output
Frequency frequency and voltage in the
constant output area. Normally,
B
this setting is not required.
Note: When using a high-speed N t
Mid
frequency
B
Output voltage (V) O t
E1-12 Mid. Output
VMA
Frequency
E1-05
Voltage B
E1-12
E1-13
Mid voltage
B
0
E1-13 Base
Voltage
Note: Set as follows:
Base
Note: This parameter becomes
voltage
Note 1. These are values for a 200-V class Inverter. Double these values for a 400-V class Inverter.
Note 2. When the control mode is changed, the Inverter reverts to default settings. (The open loop
vector control default settings are given above.)
H Motor Setup: E2
Name
Para
meter meter
Display
No.
name
E2-01 Sets the motor rated current in
Motor rated
current 1-A units.
Note: These set values will be-
Motor
Rated FLA
E2-02 Sets the motor rated slip in Hz
Motor rated
slip units.
Note: These set values will be-
Motor
Rated Slip
E2-03 Sets the motor no-load current
Motor
no-load in 1-A units.
current
Note: These values will be auto Note: These values will be auto-
No-Load
Current
7-26
Description Description
Wh i hi h d
motor, set the characteris-
tics of the constant output
area.
t lt (V)
FA E1-11 FMAX
E1-06 E1-06 E1-04 E1-04
Frequency (Hz)
E1 06<E1 11<E1 O4. E1-06<E1-11<E1-O4.
disabled if E1-11 and
E1-12 are set to "0."
Description
come the reference val-
ues for motor protection,
torque limits and torque torque limits and torque
control.
These values will auto-
matically be set if they
were set during auto-tun-
ing.
come the reference val- come the reference val-
ues for slip compensation.
These values will be auto-
matically set if auto-tuning
is started.
matically set if auto-tuning
is started.
Setting Setting Default Default Chan- Chan-
range range setting setting ges ges
during during
opera- opera-
tion tion
0.0 to 0.0 NO
400.0
0.0 to 0.0 NO
255.0
(See
note 1.)
0.0 to 0.0 NO
255.0
(See
note 1 ) note 1.)
Setting Default Chan-
range range setting setting ges ges
during
opera-
tion
0.32 to 1.90 NO
6.40 (See
(See note 1.)
note 2.)
0.00 to 2.90 NO
20.00 (See
note 1.)
0.00 to 1.20 NO
2.9 (See
(See ( note 1.) )
note 3.) t 3 )
Chapter 7
Control mode
V/f V/f Open
control with loop
PG vector
A A A
A A A
A A Q
Control mode
V/f V/f Open
control with loop
PG vector
Q Q Q
A A Q
A A Q
Page Page
Flux
vector
A ---
A ---
Q ---
Page
Flux
vector
Q 5-23,
5-44,
6-9,
6-32
Q 6-10,
6-15,
6-32
Q 6-10,
6-15,
6-32