Omron SYSDRIVE 3G3FV User Manual page 248

Advanced Operation
Explanation of Settings
Setting
0 1F
1 6F
2 10F
3 12F
4 36F
Note "F" indicates the output frequency (Hz). For example, if "0" (1F) is set, when the output frequency
is 60 Hz there will be an output of 60 pulses per minute. (Duty 50%)
H Setting a Wired SYSMAC BUS Interface Card (F8)
When using a 3G3IV-PSIG Wired SYSMAC BUS Interface Card, set the following parameter in order to
specify the operation of the Inverter for communications failures.
Parameter Display name p y
number
F8-01 E-15 Det Sel
Set the parameter according to the application.
Setting
0 Deceleration 2: Decelerates to a stop
with C1-02 set.
1 Coast to a stop.
2 Emergency stop time: Decelerates to a
stop according to the C1-09 setting.
3 Continuous operation. (See note.)
Note If the parameter is set to 3, the Inverter will operate without references from the host controller.
Take necessary measures, such as emergency stop measures, to ensure safety.
H Setting a CompoBus/D Communications Card (F9)
When using a 3G3FV-PDRT1-SIN CompoBus/D Communications Card, make the communications
settings with the following parameters.
Setting Communications External Fault Input
Set the following three parameters to specify the detection method of communications external fault
input.
Parameter Display name p y
number
F9-01 EF0 Selection
Explanation of Settings
Setting
0 Normally open contact. (A communications external fault is input with the bit turns ON.)
1 Normally close contact. (A communications external fault is input with the bit turns OFF.)
6-74
Setting g Units Default
range setting
0 to 3 --- 1
Description
Setting g Units Default
range setting
0, 1 --- 0
Description
Valid access levels
V/f V/f with
Control PG
Basic or Advanced
Inverter's status
Fault
Fault
Fault
Alarm
Valid access levels
V/f V/f with
Control PG
Basic or Advanced
Description
Chapter 6
Open Loop Flux
Vector Vector
Fault output
ON
ON
ON
OFF
Open Loop Flux
Vector Vector