Creating Ipv4-Acls Or Ipv6-Acls In Device Manager - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Creating IPv4-ACLs or IPv6-ACLs with the IP-ACL Wizard
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Click Up or Down to order the filters in this IP-ACL.
Step 8
Tip
Step 9 Click Next.
You see a list of switches that you can apply this IP-ACL.
Step 10 Uncheck any switches that you do not want to apply this IP-ACL.
Step 11 Select the Interface you want to apply this IP-ACL.
Step 12 Click Finish to create this IP-ACL and apply it to the selected switches.

Creating IPv4-ACLs or IPv6-ACLs in Device Manager

To add entries to an existing IPv4-ACL or an IPv6-ACL using Device Manager, follow these steps:
Step 1 Choose Security > IP ACL.
You see the IP ACL dialog box shown in
Figure 42-2
Step 2 Click Create to create an IP-ACL profile.
You see the Create IP ACL Profiles dialog box shown in
Figure 42-3
Enter an IP-ACL profile name.
Step 3
Cisco MDS 9000 Family CLI Configuration Guide
42-6
Order the IP filters carefully. Traffic is compared to the IP filters in order. The first match is
applied and the rest are ignored.
IP ACL Dialog Box
Create IP ACL Profiles Dialog Box
Chapter 42 Configuring IPv4 and IPv6 Access Control Lists
Figure 42-2.
Figure 42-3.
OL-16184-01, Cisco MDS SAN-OS Release 3.x