HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 381

Chapter 20 Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 20-4
Reason Code (long version)
Link failure or not connected
SFP not present
Initializing
Reconfigure fabric in progress The fabric is currently being reconfigured.
Offline
Inactive
Hardware failure
Error disabled
FC redirect failure
No port activation license
available
SDM failure
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Reason Codes for Nonoperational States
Description
The physical layer link is not operational.
The small form-factor pluggable (SFP) hardware is not
plugged in.
The physical layer link is operational and the protocol
initialization is in progress.
The Cisco SAN-OS software waits for the specified
R_A_TOV time before retrying initialization.
The interface VSAN is deleted or is in a suspended
state.
To make the interface operational, assign that port to a
configured and active VSAN.
A hardware failure is detected.
Error conditions require administrative attention.
Interfaces may be error-disabled for various reasons.
For example:
Configuration failure.
•
Incompatible buffer-to-buffer credit configuration.
•
To make the interface operational, you must first fix the
error conditions causing this state; and next,
administratively shut down or enable the interface.
A port is isolated because a Fibre Channel redirect is
unable to program routes.
A port is not active because it does not have a port
license.
A port is isolated because SDM is unable to program
routes.
Cisco MDS 9000 Family CLI Configuration Guide
Fibre Channel Interfaces
Applicable
Modes
All
20-9