Call Home Communications Test; Configuring Emc Call Home - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Call Home Communications Test

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Call Home Communications Test
To test the Call Home function and simulate a message generation using Fabric Manager, follow these
steps:
Step 1 Select a switch in the Fabric pane.
Step 2 Expand Switches, expand Events, and select Call Home in the Physical Attributes pane.
You see the Call Home information in the Information pane.
Step 3 Click the Test tab.
You see the configured tests for the switch and the status of the last testing.
Step 4 Select a switch in the Information pane.
Select test or testWithInventory from the TestAction drop-down list in the row for that switch.
Step 5
Click the Apply Changes icon to run the test.
Step 6

Configuring EMC Call Home

This feature is configured using Fabric Manager Web Server or by editing the server.properties file. The
documentation for configuring EMC Call Home using Fabric Manager Web Server is contained in the
Web Server Admin > Configure > Preferences web page.
EMC Call Home enables notification of hardware and software failures only. If this option is disabled,
then the system sends notifications of all port failures, link failures, reboots, and shutdowns.
The EMC Call Home feature requires the following:
•
•
•
Switches can forward events (SNMP traps/informs) up to 10 destinations.
Note
Table 64-1
Table 64-1
SNMP Trap
connUnitStatusChange
cefcModuleStatusChange
cefcPowerStatusChange
cefcFRURemoved
cefcFanTrayStatusChange
Cisco MDS 9000 Family CLI Configuration Guide
64-16
EMC Call Home must be enabled in the server.properties file.
You must specify an SMTP mail server and a reply-to email address in the server.properties file.
Fabric Manager must be monitoring the fabric and is able to receive traps from the fabric.
includes all the traps for EMC Call Home.
EMC Call Home Traps
Send EMC Call Home When
operStatus == failed(5)
operStatus != {ok(2), boot(5), selfTest(6), poweredUp(16),
syncInProgress(21)}
operStatus = {offDenied(4),
offEnvPower(5),offEnvTemp(6),offEnvFan(7),failed(8)}
all
all
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 64 Configuring Call Home