Creating Iscsi Interfaces; Using The Iscsi Wizard - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 50 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 50-5
The Control tab is the default tab. You see the iSCSI enable status for all switches in the fabric that
contain IPS ports.
Choose enable from the Command column for each switch that you want to enable iSCSI on.
Step 2
Click the Apply Changes icon to save these changes.
Step 3
When you disable this feature, all related configurations are automatically discarded.
Caution

Creating iSCSI Interfaces

Each physical Gigabit Ethernet interface on an IPS module or MPS-14/2 module can be used to translate
and route iSCSI requests to Fibre Channel targets and responses in the opposite direction. To enable this
capability, the corresponding iSCSI interface must be in an enabled state.

Using the iSCSI Wizard

To use the iSCSI wizard in Fabric Manager, follow these steps:
Click the iSCSI Setup Wizard icon.
Step 1
You see the iSCSI Wizard Configure Initiator dialog box shown in
OL-16184-01, Cisco MDS SAN-OS Release 3.x
iSCSI Tables in Fabric Manager
Figure 50-6.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring iSCSI
50-5