HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 645

Chapter 32 Configuring Fibre Channel Routing Services and Protocols
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 32-10
Click Create to create a static route.
Step 2
You see the Create Route dialog box shown in
Figure 32-11
Step 3 Select the VSAN ID that for which you are configuring this route.
Step 4 Fill in the destination address and destination mask for the device you are configuring a route.
Step 5 Select the interface that you want to use to reach this destination.
Step 6 Select the next hop domain ID and route metric.
Step 7 Select either the local or remote radio button.
Step 8 Click Create to save these changes, or click Close to discard any unsaved changes.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Fibre Channel Static Route Configuration Dialog Box
Create Fibre Channel Route Dialog Box
Figure 32-11.
Cisco MDS 9000 Family CLI Configuration Guide
FSPF Routes
32-13