Using The Quick Config Wizard - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 30 Configuring and Managing Zones
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Using the Quick Config Wizard

The Quick Config Wizard supports only switch interface zone members.
Note
As of Cisco SAN-OS Release 3.1(1) and later, you can use the Quick Config Wizard on the Cisco MDS
9124 Switch to add or remove zone members per VSAN. You can use the Quick Config Wizard to
perform interface-based zoning and to assign zone members for multiple VSANs using Device Manager.
The Quick Config Wizard is supported on the Cisco MDS 9124 Fabric Switch, the Cisco MDS 9134
Note
Fabric Switch, the Cisco Fabric Switch for HP c-Class BladeSystem, and the Cisco Fabric Switch for
IBM BladeCenter.
The Quick Config Wizard can only be used on stand-alone switches that do not have any existing zoning
Caution
defined on the switch.
To add or remove ports from a zone and to zone only the devices within a specific VSAN using Device
Manager on the Cisco MDS 9124 Switch, follow these steps:
Step 1 Choose FC > Quick Config or click the Zone icon in the toolbar.
You see the Quick Config Wizard (see
dialog box (see
Note
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Figure 30-4), which shows all unsupported configurations.
You will see the Discrepancies dialog box only if there are any discrepancies.
Figure 30-5) with all controls disabled and the Discrepancies
Cisco MDS 9000 Family CLI Configuration Guide
Using the Quick Config Wizard
30-7