Chapter 18
Managing System Hardware
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 18-5
Select Out of Service to gracefully shut down the integrated crossbar.
Step 2
Note
Caution
Taking the crossbar out of service may cause a supervisor switchover.
To perform a graceful shutdown of integrated crossbars on the supervisor module in a Cisco MDS 9509
or 9506 Director using Device Manager, follow these steps:
Right-click the external crossbar switching module.
Step 1
You see the context menu for that module.
Step 2
Select Out of Service to gracefully shut down the external crossbar switching module.
Note
To reactivate the external crossbar module, you must remove and reinsert or replace the crossbar module.
Taking the crossbar out of service may cause a supervisor switchover.
Caution
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Shutting Down a Crossbar
To reactivate the integrated crossbar, you must remove and reinsert or replace the Supervisor-1
or Supervisor-2 module.
About Crossbar Management
Cisco MDS 9000 Family CLI Configuration Guide
18-9