Configuring An Allowed-Active List Of Vsans; Default Settings - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 24-7
Switch 1
VSAN1
VSAN2
VSAN3
VSAN4
VSAN5

Configuring an Allowed-Active List of VSANs

To configure an allowed-active list of VSANs for an interface using Fabric Manager, follow these steps:
Expand Interfaces and then select FC Physical.
Step 1
You see the interface configuration in the Information pane.
Click the Trunk Config tab.
Step 2
You see the current trunk configuration.
Step 3 Set Allowed VSANs to the list of allowed VSANs for each interface that you want to configure.
Step 4 Click Apply Changes to save these changes or click Undo Changes to discard any unsaved changes.
Default Settings
Table 24-2
Table 24-2
Parameters
Switch port trunk mode
Allowed VSAN list
Trunking protocol
Cisco MDS 9000 Family CLI Configuration Guide
24-6
Operational and Allowed VSAN Configuration
lists the default settings for trunking parameters.
Default Trunk Configuration Parameters
Chapter 24
Switch 2
VSAN1
VSAN2
VSAN3
Switch 3
VSAN1
VSAN2
VSAN4
VSAN5
Default
On.
1 to 4093 user-defined VSAN IDs.
Enabled.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring Trunking