Configuring The Initiator Version - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Optional IKE Parameter Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 44-11
Select the Global tab.
Step 2
You see the global statistics of a specific IKE protocol in the Information pane (see
Figure 44-12
Step 3 Enter a value (in seconds) in the KeepAliveInterval (sec). the The keepalive interval in seconds is used
by the IKE entity on the managed device with all the peers for the DOI corresponding to this conceptual
row.
Click Apply Changes to save your changes.
Step 4

Configuring the Initiator Version

To configure the initiator version using Fabric Manager, follow these steps:
Step 1 Expand Switches > Security and then select IKE.
Cisco MDS 9000 Family CLI Configuration Guide
44-18
IKE Configuration
IKE Global Tab Information
Chapter 44 Configuring IPsec Network Security
Figure
OL-16184-01, Cisco MDS SAN-OS Release 3.x
44-12).