Module Logging - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 63 Configuring System Message Logging
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
You see the switch information shown in
Figure 63-2
Step 4 Select a switch in the Information pane.
Step 5 Select a severity level from the Console Severity drop-down list in the row for that switch.
Step 6 Click the Apply Changes icon.

Module Logging

By default, logging is enabled at level 7 for all modules. You can enable or disable logging for each
module at a specified level.
To configure the severity level for a logging facility, follow these steps:
In Fabric Manager, expand Switches, expand Events and select SysLog in the Physical Attributes pane.
Step 1
In Device Manager, choose Logs > Syslog > Setup and click the Switch Logging tab in the Syslog
dialog box.
You see the switch information shown in
Figure 63-3
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Figure
Switch Logging Tab in Fabric Manager
Figure 63-3
Switch Logging Tab in Fabric Manager
System Message Logging Configuration
63-2.
or Figure 63-4.
Cisco MDS 9000 Family CLI Configuration Guide
63-5