Configuring Rate Mode - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Configuring Generation 2 Module Interface Shared Resources
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 22-6
The auto parameter enables autosensing on the interface. The autoMax2G parameter enables
autosensing on the interface with a maximum speed of 2 Gbps.
Note
Step 5 Click the Apply Changes icon.
.

Configuring Rate Mode

To configure the rate mode (dedicated or shared) on an interface on a 48-port or 24-port 4-Gbps Fibre
Channel switching module using Fabric Manager, follow these steps:
Select a switch from the Fabric pane, or select a group of switches (SAN, fabric, VSAN) from the
Step 1
Logical Domains pane.
Expand Switches > Interfaces and then select FC Physical from the Physical Attributes pane.
Step 2
You see the FC Physical > General tab in the Interfaces pane.
Scroll until you see the row containing the switch and port you want to configure.
Step 3
Select dedicated or shared from the Rate Mode column (see
Step 4
Figure 22-7
Cisco MDS 9000 Family CLI Configuration Guide
22-22
Speed Admin column in Port Configuration
If you change the port bandwidth reservation parameters on a 48-port or 24-port 4-Gbps Fibre
Channel switching module, the change affects only the changed port. No other ports in the port
group are affected.
Rate Mode Port Configuration
Chapter 22 Configuring Generation 2 Switches and Modules
Figure 22-7).
OL-16184-01, Cisco MDS SAN-OS Release 3.x