About Ipv4 - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Cisco mds 9000 family fabric manager configuration guide, release 3.x (ol-8222-10, april 2008)
Hide thumbs Also See for Cisco MDS 9216 - Fabric Switch:
Table of Contents

Advertisement

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Configuring IPv4 for Gigabit Ethernet Interfaces
Cisco MDS 9000 Family supports IP version 4 (IPv4) on Gigabit Ethernet interfaces. This chapter
describes how to configure IPv4 addresses and other IPv4 features.
This chapter includes the following topics:

About IPv4

Both FCIP and iSCSI rely on TCP/IP for network connectivity. On each IPS module or MPS-14/2
module, connectivity is provided in the form of Gigabit Ethernet interfaces that are appropriately
configured. This section covers the steps required to configure IP for subsequent use by FCIP and iSCSI.
Note
For information about configuring FCIP, see
configuring iSCSI, see
A new port mode, called IPS, is defined for Gigabit Ethernet ports on each IPS module or MPS-14/2
module. IP storage ports are implicitly set to IPS mode, so it can only be used to perform iSCSI and FCIP
storage functions. IP storage ports do not bridge Ethernet frames or route other IP packets.
Each IPS port represents a single virtual Fibre Channel host in the Fibre Channel SAN. All the iSCSI
hosts connected to this IPS port are merged and multiplexed through the single Fibre Channel host.
In large scale iSCSI deployments where the Fibre Channel storage subsystems require explicit LUN
access control for every host device, use of proxy-initiator mode simplifies the configuration.
The Gigabit Ethernet interfaces on the MPS-14/2 module do not support EtherChannel.
Note
To configure IPv6 on a Gigabit Ethernet interface, see the
Note
IPv6 Routing" section on page
OL-16184-01, Cisco MDS SAN-OS Release 3.x
About IPv4, page 53-1
Basic Gigabit Ethernet Configuration for IPv4, page 53-2
VLANs, page 53-4
IPv4-ACLs, page 53-5
Default Settings, page 53-6
Chapter 50, "Configuring iSCSI."
C H A P T E R
Chapter 48, "Configuring FCIP."
54-11.
Cisco MDS 9000 Family CLI Configuration Guide
53
For information about
"Configuring IPv6 Addressing and Enabling
53-1

Advertisement

Table of Contents
loading

Table of Contents