Chapter 48
Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 48-17
Step 13
Click Finish to create this FCIP link.
Basic FCIP Configuration
Once you have created FCIP links using the FCIP wizard, you may need to modify parameters for these
links. This includes modifying the FCIP profiles as well as the FCIP link parameters. Each Gigabit
Ethernet interface can have three active FCIP links at one time.
Once you have created FCIP links using the FCIP wizard, you may need to modify parameters for these
links. This includes modifying the FCIP profiles as well as the FCIP link parameters. Each Gigabit
Ethernet interface can have three active FCIP links at one time.
To configure an FCIP link, follow these steps on both switches:
Step 1
Configure the Gigabit Ethernet interface.
Step 2
Create an FCIP profile, and then assign the Gigabit Ethernet interface's IP address to the profile.
Step 3
Create an FCIP interface, and then assign the profile to the interface.
Step 4
Configure the peer IP address for the FCIP interface.
Step 5
Enable the interface.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Enter FICON Port Address
Cisco MDS 9000 Family CLI Configuration Guide
Using the FCIP Wizard
48-15