Ethernet Portchannels And Fibre Channel Portchannels; Configuring Fcip - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 48

Configuring FCIP

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•

Ethernet PortChannels and Fibre Channel PortChannels

Ethernet PortChannels offer link redundancy between the Cisco MDS 9000 Family switch's Gigabit
Ethernet ports and the connecting Ethernet switch. On the other hand, Fibre Channel PortChannels also
offer (E)ISL link redundancy between Fibre Channel switches. FCIP is an (E)ISL link and is only
applicable for a Fibre Channel PortChannel. Beneath the FCIP level, an FCIP link can run on top of an
Ethernet PortChannel or just on one Gigabit Ethernet port. This link is totally transparent to the Fibre
Channel layer.
An Ethernet PortChannel restriction only allows two contiguous IPS ports, such as ports 1–2 or 3–4, to
be combined in one Ethernet PortChannel (see the
section on page
PortChannel (to which FCIP link can be a part of) does not have a restriction on which (E)ISL links can
be combined in a Fibre Channel PortChannel as long as it passes the compatibility check (see the
"Compatibility Check" section on page
be put into a Fibre Channel PortChannel is 16 (see
Figure 48-8
Gigabit Ethenet link
To configure Fibre Channel PortChannels, see
Ethernet PortChannels, see the
Configuring FCIP
This section describes how to configure FCIP and includes the following topics:
•
•
OL-16184-01, Cisco MDS SAN-OS Release 3.x
The FCIP link stays up during the failover.
52-8). This restriction only applies to Ethernet PortChannels. The Fibre Channel
PortChannels at the Fibre Channel and Ethernet Levels
Fibre Channel PortChannel
Fibre Channel
FCIP
TCP
IP
Ethernet
Ethernet PortChannel
Gigabit Ethenet link
Enabling FCIP, page 48-8
Basic FCIP Configuration, page 48-15
"Configuring Gigabit Ethernet High Availability"
23-14). The maximum number of Fibre Channel ports that can
Figure
Fibre Channel
Gigabit Ethenet link
Chapter 23, "Configuring PortChannels."
"Configuring High Availability" section on page
Cisco MDS 9000 Family CLI Configuration Guide
48-8).
FCIP
TCP
IP
Ethernet
17-1.
Configuring FCIP
To configure
48-7