HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 1293

Chapter 69 Management Software FAQ
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 69-2
Tooltip
escFailureIsolation
fabricBindingDBMismatch
fabricBindingDomainInvalid
fabricBindingNoRspFromPeer
fabricBindingSWWNNotFound
fcipPortAdminCfgChange
fcipPortKeepAliveTimerExpire
fcipPortMaxReTx
fcipPortPersistTimerExpire
fcipPortSrcAdminDown
fcipPortSrcLinkDown
fcipSrcModuleNotOnline
fcipSrcPortRemoved
fcotChksumErr
fcotNotPresent
fcotVendorNotSupported
fcspAuthenfailure
ficonBeingEnabled
ficonNoPortnumber
ficonNotEnabled
ficonVsanDown
firstPortNotUp
firstPortUpAsEport
hwFailure
OL-8007-10, Cisco MDS SAN-OS Release 3.x
Device Manager Tooltip Definitions (continued)
Definition
During a port initialization the prospective
Interconnect_Ports are unable to proceed with
initialization as a result of Exchange Switch
Capabilities (ESC).
fabric bindingactive database mismatch with
peer.
Peer domain ID is invalid in fabric binding active
database.
Fabric binding no response from peer.
Peer switch WWN not found in fabric binding
active database.
FCIP port went down due to configuration
change.
FCIP port went down due to TCP keep alive timer
expired.
FCIP port went down due to max TCP
retransmissions reached the configured limit.
FCIP port went down due to TCP persist timer
expired.
FCIP port went down because the source ethernet
link was administratively shutdown.
FCIP port went down due to ethernet link down.
FCIP port went down due to source module not
online.
FCIP port went down due to source port removal.
FSP SPROM checksum error.
SFP (GBIC) not present.
FSP (GBIC) vendor is not supported.
Fibre Channel security protocol authorization
failed.
FICON is being enabled.
No FICON port number.
FICON not enabled.
FICON VSAN is down.
In a over subscribed line card, first port cannot be
brought up in E mode when the other ports in the
group are up.
In a over subscribed line card, when the first port
in a group is up in E mode, other ports in that
group cannot be brought up.
Hardware failure.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Other
69-15