HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 596

Zone Sets
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 30-18
Step 6 Check the Save Running to Startup Configuration check box to save all changes to the startup
configuration.
Click Continue Activation to activate the zone set, or click Cancel to close the dialog box and discard
Step 7
any unsaved changes.
You see the Zone Log dialog box, which shows if the zone set activation was successful (see
Figure
Figure 30-19
To deactivate an existing zone set, follow these steps:
Right-click the zone set you want to deactivate and then click Deactivate from the pop-up menu.
Step 1
Click OK in the confirmation dialog box to deactivate the zone set.
Step 2
Cisco MDS 9000 Family CLI Configuration Guide
30-18
Save Configuration Dialog Box
30-19).
Zone Log Dialog Box
Chapter 30 Configuring and Managing Zones
OL-16184-01, Cisco MDS SAN-OS Release 3.x