Gerber OMEGA CP Reference Manual page 757

Adding instructions to a job
When you send a job to a local or network resource, you can add instructions to the job.
The Gerber Queue Manager icon will flash indicating to the operator that the message contains
instructions or an error message. The dialog box displays the instructions as well as helpful job
and material information. Queue Manager will not send the job to an output device until it is
opened and the operator acknowledges the message by clicking OK.
To create a message in Gerber Queue Manager
1 In GSPPlot, click Setup > Job Instructions to open the Job Instructions dialog box.
2 Type in any applicable job instructions.
3 Click OK. These instructions will appear in Gerber Queue Manager when the job is
sent to a plotter or to a Gerber thermal printer.
To view Job Instructions
1 When the Gerber Queue Manager icon flashes click it to open the Operator
Instructions dialog box.
2 Read the instructions and click OK.
743