Gerber OMEGA CP Reference Manual page 654

640 Chapter 58:
Advanced Setup Options
The Output by Layer option in the Select Colors dialog box allows you to dynamically switch
between layered print order and a flat print order. When Output by Layer is turned off,
GSPPlot rebuilds a print order based on front to back stacking order. Any manual changes that
may have been made to the Composer print order are not maintained.
By default, GSPPlot will use the Composer Print Order whenever possible. If the PLT file has a
flat Print Order, that Print Order will be used when Output by Layer is turned off.
To choose specific layers, vinyls, or foils to output
1 Click Setup > Select Colors to open the Select Colors dialog box.
2 Turn on Output by Layer to view the layered print order or clear the checkbox to
create a flattened print order.
3 Choose the layers, vinyls, or foils not to output by clearing their checkboxes.
4 When outputting by layer, turn on Rewind Between Layers to have each layer
print on top of the previous layer. You must have Reduce Frame turned off so
that the layers register with each other.
5 Click OK.
Tip: Use the check box, No EDGE Prompts for single-foil jobs. If turned on, any printing
information that is sent to an EDGE, EDGE 2 or GERBER EDGE FX will have vinyl and foil
messages omitted. The EDGE will then assume all the correct foil and vinyl has been loaded,
and will begin printing with no operator intervention.
Merging specific layers before outputting
The Select Colors dialog box also permits you to merge selected layers before outputting. Turn
on the layers to merge and clear the checkboxes for the layers that will not be merged. Select the
Merge Layers option in the Select Colors dialog box.