Gerber OMEGA CP Reference Manual page 661

2 Click the scroll arrow to open the Vinyl Family list. Choose the Vinyl Family that
matches the material on which the EDGE is printing.
3 Use the Settings controls to lighten or darken the print, and then click OK to return to
the Print Options dialog box.
Tip: Using the Settings controls is like adjusting darkness and lightness on a copy machine.
Changing the darkness of prints for the MAXX 2
When printing, the MAXX 2 automatically adjusts to the amount of heat needed to apply a
specific foil. The Print Settings dialog box in GSPPlot allows you to select a Lighter or Darker
setting for each foil in a print job including Normal and Overprint foils.
The MAXX 2 auto-adjusts the heat use to apply each foil. Print Settings gives you the ability to
change that heat setting. For example, if a foil is cracking, then the heat setting may be too high.
Once in the Print Settings dialog box your choices will be Lighter or Auto. If the heat setting is
too low and seams appear, then in the Print Settings dialog box your choices will be Darker or
Auto.
To change the Print Settings
1 In GSPPlot click Setup > Print Options to open the Print Options dialog box.
2 Click Settings... to open the GERBER MAXX Print Settings dialog box.
3 Click a new heat setting for the foil and substrate combination.
4 Click OK to save the setting and return to the Print Options dialog box.
5 Click OK to return to GSPPlot.
Tip: Using the Settings controls is like adjusting darkness and lightness on a copy machine.
647