Gerber OMEGA CP Reference Manual page 652

638 Chapter 58:
Advanced Setup Options
To size a job proportionally by altering its length
1 Click Layout > Layout to open the Layout dialog box
2 In the Size group box enter a value in the Free Length text box.
3 Click Continue.
Changing the size of a job by scale
Changing a job by scale enables you to increase or decrease the size by a factor as opposed to a
specific length. A scale of 1.00 outputs a job at full size; a scale of 0.5 outputs the job at half the
size; a scale of 1.5 outputs the job at 50% larger than full size. When changing the scale of a job,
the new size of the job is automatically displayed in the Height and Free Length text boxes.
To size the job by scale
1 Click Layout > Layout to open the Layout dialog box.
2 In the Size group box enter a value in the Scale text box.
3 Click Continue.