Gerber OMEGA CP Reference Manual page 634

620 Chapter 55:
Managing Files in GSPPlot
the check box is only available if the Output by Layer option is set in GSPPlot. The default is to
use the Composer Print Order whenever possible.
Pause Before Rewind
In the Print Order dialog box, turn on Pause Before Rewind check box to direct the GERBER
EDGE® to pause at the end of each foil printing. The message on the LCD screen will say
. For the GERBER EDGE and EDGE 2 press the On-Line key. For the GERBER
On-Line to continue
EDGE FX, press one of the function keys to continue. The GERBER EDGE FX requires firmware
revision F.0 build 29 or newer to support this command.
Targets
Because each layer behaves like a separate job, each layer in a thermal print job will get targets
(if targets are turned on).
GSPPlot Toolbar
Click the Output by Layer button
Prior and Next Vinyl
When the Output by Layer option is active the Prior Vinyl and Next Vinyl buttons
the toolbar can be used to scroll between layers.
Select Colors dialog box
Click Setup > Select Colors or the Select Colors button
box. The Output by Layer checkbox is shown in the following illustration.
You can rebuild a Print Order for the layers that were output by turning off the Output By
Layers checkbox. GSPPlot creates a Print Order based on front to back stacking order. Any
manual Print Order changes made in Composer are not maintained.
on the GSPPlot toolbar to turn this option on or off.
to open the Select Colors dialog
Press
on