Gerber OMEGA CP Reference Manual page 722

708 Chapter 64:
Ensuring Print-to-Cut Registration
4 After the last target is captured, a message appears to Install Knife Tool in the plotter.
5 Install the knife in the plotter, and close the cover if it is open.
6 Press Enter to cut the job.
Note: Once you have selected the first target you may skip the next three by using the plotter
control panel to move to the next target without collecting coordinates from that skipped target.
You can also back up to past targets.
Graphtec Type 2 plotters
When outputting a job to a Graphtec Type 2 plotter, with automatic target acquisition, you can
choose to print four right angle targets rather than normal cross hair targets. Graphtec Type 2
targets are only available when the 4 Corners option is chosen in the Target Configuration
dialog box.
To print Graphtec Type 2 (right angle) targets
1 Click Setup > Print Options to open the Print Options dialog box.
2 Click Targets to open the Target Configuration dialog box.
3 Turn on 4 Corners.
4 Turn on Graphtec Type 2.
5 Click OK.
Changing the target foil color
GSPPlot assigns the first spot color listed in the Print Options dialog box as the target foil. You
may wish to change the target foil if the target color and the material color are similar since this
can make plotter alignment difficult. The target foil is designated as a "T" in the Print Options
dialog box, located to the right of the foil colors.
When printing with process colors, each color will be assigned as a target foil.
There are two methods for changing target foils:
♦ Using the Print Options dialog box
♦ Using the Target Configuration dialog box
To change the target foil using Print Options
1 Click Setup > Print Options to open the Print Options dialog box.