Gerber OMEGA CP Reference Manual page 714

700 Chapter 64:
Ensuring Print-to-Cut Registration
4 Click Layout > Weed Border to turn off the weed border.
5 Click Setup > Device Select to open the Plotter/Printer Select dialog box.
6 Choose the plotter to calibrate from the Plotters list.
7 Choose the printer from the Vinyl Printers list.
8 Click OK.
9 Click File > Print to Device to send the calibration pattern to the printer.
10 Print the file according to the instructions on the printer.
11 Load and align the printed test pattern in the chosen plotter.
12 Click File > Cut/Pounce. The plotter will cut a frame around the edge of the
calibration pattern. Use the test pattern to determine the need for plotter calibration.
To test plotter calibration
1 After cutting a calibration pattern, remove the outermost vinyl at the edge of the
pattern. Leave the calibration pattern and the surrounding vinyl in place.
2 Examine the top edge of the calibration pattern. Each bar has a number at the top.
Some of the black bars have extended past the cutting area or calibration frame. Make
a note of the number of the last bar without black outside the calibration frame.