Altigen AltiContact Manager Version 5.0A Administration Manual page 224

Quantum Trunk Properties
Quantum Trunk General Configuration
Parameter
Interface Type
Impedance
Incoming Ring
Type
Centrex Flash
Duration (ms)
Detect Trunk
Status By Loop
Current
Enable Caller ID
Receive
Out of Service
With Trunk
Seizure
7-8 AltiContact Manager Administration Manual
Description
Select from:
•
Loop Start
•
Ground Start
•
DID (Wink Start)—available only if the selected
trunk is a DID trunk
The resistance of electrical current to alternating current,
measured in OHMs. Impedance occurs when power or
signal is transferred from one circuit to another. The
setting options are:
•
600 OHMs (domestic setting)
•
900 OHMs (international setting, depending on the
country)
•
External
Select single or double.
Specifies the Flash Duration time in milliseconds, with a
range from 50 ms to 1000 ms. This setting complements
the Centrex Flash Support option in the General tab for
the trunk.
When selected, causes detection of the Quantum trunk
status using a loop current.
Select for user to receive caller ID digits.
When selected, if the trunk is set to Out of Service, the
Quantum service provider will busy out (seize) the trunk.
The CO will treat this trunk as a busy line and WILL
NOT place a call to this trunk. (By default, this option is
unchecked.)