Table of Contents
Advertisement
— Keep Messages as Saved
Further, if you enable mail forwarding, you can use the check boxes
whether you want to Forward Email, Forward Voice Mail, or both.
Changing the Extension Location or Type
Changing the Type
The type of extension is set when you create the extension: physical, virtual
or huntgroup/workgroup pilot, described on page 10-1. After you create the
extension, the type is displayed as a Type radio button list in the General
window.
You can change a Virtual extension to a Physical one, and vice versa, but
you cannot change either to a Huntgroup or Workgroup number, nor can
you change a huntgroup or workgroup number to another type after it is
created.
If you change the type to physical, you can also set the location and
configure the line as discussed in the subsequent paragraphs.
Changing the Location
When you create a physical extension, you assign it a location or you accept
an automatically assigned location. If you have available extensions, you
can change the location in the General window.
To change the location, select the extension number in the list of
extensions, then click the Previous or Next buttons to change the slot and
channel settings until the location you want is displayed. Like other
changes, this change isn't finalized until you click Apply.
Setting an IP Extension
The IP Extension option allows an H.323 compliant terminal device (IP
phone) to connect to AltiServ. IP extensions have the same features as
analog stations. For system requirements and limitations on setting up IP
extensions, see Chapter 11, Setting Up IP Extensions.
To use the IP Extension option, check the Enable IP Extension, then set
the IP addressing by choosing either Dynamic or Static IP Addressing. If
you choose Static addressing, you need to type in a Logon IP Address.
The type of addressing you use affects users:
AltiWare OE System Installation & Administration Manual
Extension and Group Configuration
10-11
Advertisement
Table of Contents
Troubleshooting
