You can click the Reset button without selecting an extension, and then
type in the extension number for the extension to reset.
Trunk View Window
The Trunk View window displays the status of all assigned trunks.
Figure 5. Trunk View window
The radio button to the left of each trunk location is green when the trunk
is idle, and red when the extension is not ready or in use. The location
format is slot:channel—for example, channel 3 on the board in slot 9 is
location 09:03. The Type, Status and Duration of trunk use is also
displayed.
Note:
The Duration field only displays the duration of the trunk if the
call is connected after AltiWare Administrator is started. The field
will be empty if the trunk is in Idle, not ready, out of service or the
call was connected prior to AltiWare Administrator being
launched.
You can double click any trunk location to open the Trunk Configuration
window for the selected trunk.
The Reset button resets the selected trunk(s) to the idle status. You'll be
asked to confirm the reset and a status message will tell you if the reset was
successful.
AltiWare OE System Installation & Administration Manual
Getting Around AltiAdmin
4-7