Table of Contents
Advertisement
Configuring the Triton T1/E1/PRI Board
protocol for real-time applications used to transport packetized voice
packets over the IP network.
5.
Check the AltiWare IP Dialing Table for Dialed Digits Length.
Refer to "Defining an IP Dialing Table" on page 5-28.
6.
Check if Called Extension is a Workgroup or has Multiple Call
Waiting Enabled. When the called party is a workgroup pilot number
or has Multiple Call Waiting enabled, the caller is placed on hold and
hears ringback or music.
IP Trunk Does Not Appear in Trunk View
When an IP trunk doesn't appear in the Trunk View, there are two possible
causes:
1.
Device Driver is Not Running - check the device driver. Make sure
it's installed and working properly.
2.
Triton VoIP Board is Not Installed Properly - Refer to the Quick
Installation Guide for more details on proper installation of the Triton
VoIP board.
Configuring the Triton T1/E1/PRI Board
Through AltiAdmin, the Triton T1/E1/PRI board can be configured for
either digital T1, E1or PRI (Primary Rate Interface).
Both T1 and PRI carry 24 pulse code modulation (PCM) signals using
time-division multiplexing (TDM) at an overall rate of 1.544 Mbps. Voice
T1 provides twenty-four 64K channels with robbed bit signaling. PRI
provides twenty-three 64K channels, using one 64K channel for D channel
messaging.
The Triton T1/E1/PRI board is used to provide voice processing resources
for AltiWare OE, similar to the way Quantum telephony boards are used
for analog trunks and extension lines. AltiWare OE uses DSP engines
residing on the Triton T1/E1/PRI board to perform the voice processing
functions needed for either T1, E1 or PRI service. Quantum and Triton
boards are connected via MVIP connectors.
For information on how to install Triton T1/E1/PRI boards, refer to the
Quick Installation Guide provided with every board package.
6-34 AltiWare OE System Installation & Administration Manual
Advertisement
Table of Contents
Troubleshooting
