Before New Installation; To Begin New Installation - Altigen AltiWare OE/ACC Version 5.0A Administration Manual

Software License Activation and Registration
New Installation

Before New Installation

Note:
Triton T1 Rev A1/A2 or VoIP Rev A1/A2 boards are not supported
in OE 5.0A. These boards must be replaced with Rev A3 or later
boards.
Before you begin, have the following at hand:
• System Key
• The 20-digit software license key (located on the End User License
Agreement)
• The system home area code
• The extension length
Note: The extension length, which is from 3–6 digits, is the number
of digits for all extension numbers. All extensions in the
AltiServ configuration must be the same length.
You cannot change the extension length once the first
extension is configured, which is something you do later
running the AltiWare Setup. To change the extension after
extensions are configured requires reconfiguring the entire
system or deleting all the extensions and groups already
configured.
• Internet Explorer 5.0A or higher (for online registration)

To Begin New Installation

To install AltiWare OE:
1. Make sure you have prepared for installation as described beginning
on page 3-2.
2. Install the System Key on the parallel or USB port.
Caution: Do not connect the system key to any AltiGen board as
damage may occur to the board or the system key.
AltiWare OE System Installation & Administration Manual 3-11