Setting Up An Altiware-To-Altiware Ip Network - Altigen AltiWare OE/ACC Version 5.0A Administration Manual

Setting Up an AltiWare-to-AltiWare IP Network

Two or more AltiWare systems can be networked together to provide
extension-to-extension connections via IP trunk calls. Users may dial a
remote AltiWare's auto attendant or direct dial to an extension, without
having to dial out through the PSTN. A diagram illustrating a multiple
AltiWare-to-AltiWare connection is provided below and is referred to as an
example throughout the configuration instructions below.
Figure 13. AltiServ-to-AltiServ Connection
Follow the steps below to configure IP trunks for an AltiWare-to-AltiWare
tie-trunk line connection:
1. Confirm that the correct number of Triton VoIP boards are installed
and connected by checking the Boards window on the Main Window
of AltiWare Administrator. Refer to "Boards View Window" on page
4-5 for more details about this window.
2. Assign the IP trunk access code on the Number Plan tab window of
System Configuration. See "IP Trunk Access" on page 5-10.
3. Configure general trunk parameters on the General tab window of
Trunk Configuration. See "Setting General Trunk Attributes" on
page 7-3.
4. Configure the dialing plan for connection to remote AltiWare systems
on the IP Dialing Table tab window of System Configuration. Set
AltiWare OE System Installation & Administration Manual
Board Configuration
6-31