Ws2000>Admin(System.snmp.traps)> Set - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

13-328 WS2000 Wireless Switch System Reference Guide
WS2000>admin(system.snmp.traps)> set
Description:
Sets SNMP trap parameters.
Syntax:
set cold
cfg
lowcf
port
dos-attack
snmp-auth
snmp-acl
mu-assoc
mu-unassoc
mu-deny-
assoc
mu-deny-auth
ap-adopt
ap-unadopt
ap-denied-
adopt
ap-radar
cf-thresh
min-pkt
dos-rate-limit
rate
<rate> Choices
pkts
mbps
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
/
enable
disable
<memory>
<pkt>
<seconds>
<rate> <scop <value
e> >
Interpretation
Packets/second > <value>
Throughput > <value>
Enables/disables the configuration changed
trap.
Enables/disables the configuration mode.
Enables/disables the low compact flash memory
trap.
Enables/disables the physical port status
change trap.
Enables/disables the denial of service trap.
Enables/disables the authentication failure trap.
Enables/disables the SNMP ACL violation trap.
Enables/disables the MU associated trap.
Enables/disables the MU unassociated trap.
Enables/disables the MU association denied
trap.
Enables/disables the MU authentication denied
trap.
Enables/disables the AP adopted trap.
Enables/disables the AP unadopted trap.
Enables/disables the AP denied trap.
Enables/disables the AP radar trap.
Sets the threshold for low compact flash
memory trap to <memory> (
Sets the minimum number of packets required
for rate traps to fire ( –
1 65535
Sets the rate limit in seconds for DOS traps to
<seconds> per trap ( –
0 2147483647
Sets the particular <rate> to monitor to <value>
given the indicated <scope>. See table below
for information on the possible values for
<rate>, <scope>, and <value>.
Allowed Range for
<value>
0-9999.99
0-108.00
– kb).
0 2147483647
).
).
Allowed <scope>
switch,wlan,ap,mu
switch,wlan,ap,mu