Mobile Unit Access Control List (Acl); Step 9: Test Connectivity - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

Wireless switch
Hide thumbs Also See for WS2000 - Wireless Switch - Network Management Device:
Table of Contents

Advertisement

For the connectivity test, set WEP 128 encryption. This ensures that communications with the switch are
secure enough for this stage. Later on, increasing the security level might be necessary.
1. Select the
WEP 128 (104-bit key)
2. To use WEP encryption with the
display a sub-screen for entering keys.
3. Add a key to
(0-9, A-E) characters. When finished, click the
Security screen.
4. Click the
Apply

Mobile Unit Access Control List (ACL)

This list is used to specify which mobile units can or cannot gain access to the WLAN. The list employs an
adoption rule for allowing or denying specific mobile units by way of exception. By default, all mobile units
can gain access.

Step 9: Test Connectivity

At this point, the switch is set up to allow mobile units to access the LAN.
1. Check and ensure that the MU is setup as a DHCP client.
2. Set the MU to use WEP 128 bit encryption. Use the same key as was entered in the WEP Key Setting
dialog. You might need to restart the MU after changing the settings.
3. Open a Web browser and type the IP address: 192.168.0.1.
The WS 2000 Switch Management screen should appear. If it does not, go back to the wired system used
to configure the switch and see if the mobile device appears in the MU Stats screen
-->
MU
Stats). If it does not appear on the MU Stats screen, recheck the network and WEP settings on
the mobile device.
4. In the Web browser, enter a URL for a site (such as www.motorola.com) on the WAN. If the site does not
appear, go to the WAN Stats screen
WAN connection.
option.
No Authentication
Key
#1, and use that key with the mobile unit. The keys consist of 26 hexadecimal
button in the WLAN Security screen to save changes.
(Status & Statistics
selection, click the
Ok
button to close this screen an return to the WLAN
-->
WAN
Stats) to review the status of the
Getting Started
WEP Key Settings
button to
(Status & Statistics
2-11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents