Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual page 645

System Component
Encryption Key Exchange
Module
Encryption Key Exchange
Module
RADIUS Module
RADIUS Module
RF Port Module
RF Port Module
RF Port Module
RF Port Module
RF Port Module
RF Port Module
RF Port Module
Rogue AP Detection Module LOG_INFO
Statistics Module
VLAN Module
VLAN Module
VLAN Module
VLAN Module
VLAN Module
VLAN Module
SIP Module
SIP Module
SIP Module
SIP Module
WIPS module
WIPS module
WIPS module
WIPS module
WIPS module
WIPS module
Debug Level
LOG_INFO [Pairwise Transient Key] Unable to get free CC buffer
LOG_INFO [Pairwise Transient Key] Group rekey after %u seconds gk_timeout
LOG_INFO rcvd access-accept from [IP_ADDR] for [MAC_ADDR]
LOG_INFO rcvd access-reject from [IP_ADDR] for [MAC_ADDR]
LOG_INFO Radio [MAC_ADDR] acs done ch=[Number]
LOG_INFO Radio [MAC_ADDR] acs in progress addr
LOG_INFO Radio [MAC_ADDR] adopted addr
LOG_INFO Radio [MAC_ADDR] inactive prtl_ptr->addr
LOG_INFO Radio [MAC_ADDR] removed prtl_ptr->addr
LOG_INFO Radio [MAC_ADDR]:non-acs status has no channel
LOG_INFO RF Port [MAC_ADDR] removed rfp_ptr->addr
Number of known APs: %u count
LOG_INFO Resetting
LOG_INFO Mapped port [Number] to subnet [Number]
LOG_INFO Mapped wlan [Number] to subnet [Number]
LOG_INFO Port [Number] has no subnet mapping port_idx
LOG_INFO Subnet [Number] disabled subnet_idx
LOG_INFO Subnet [Number] enabled subnet_idx
LOG_INFO Wlan [Number] has no subnet mapping wlan_idx
LOG_INFO SIP:Max number of SIP sessions reached on portal [address]
LOG_INFO "SIP:Create a new SIP session for call id [identifier], set state to initiated"
LOG_INFO SIP:Decrementing the number of Active SIP sessions of portal [address] to
[number]
LOG_INFO SIP:Incrementing the number of Active SIP sessions of portal [address] to
[number]
LOG_INFO WIPS is disabled
LOG_INFO WIPS: Detection in progress
LOG_INFO Could not send configuration to [MAC] Sensor was not found
LOG_INFO WIPS: Max number of sensors detected. Not adding any more
LOG_INFO AP [MAC] is converted to sensor
LOG_INFO Sensor [MAC] is successfully reverted
Log Message
A-3