Ws2000>Admin(Network.wan)> Set - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

13-122 WS2000 Wireless Switch System Reference Guide
WS2000>admin(network.wan)> set
Description:
Sets the WAN parameters. In the Web interface, this functionality if provided by the Network->WAN screen.
Syntax:
set dhcp
enable
disable
dgw
<a.b.c.d>
dns
<idx>
ipadr
<idx>
mask
<a.b.c.d>
mode
<idx>
pppoe mode
idle
<val>
ka
enable
disable
passwd
<passwd>
type
<type>
user
<userID>
Example:
admin(network.wan)>set dhcp enable
admin(network.wan)>set dgw 192.168.122.25
admin(network.wan)>set pppoe mode enable
admin(network.wan)>set pppoe type chap
admin(network.wan)>set pppoe user JohnDoe
admin(network.wan)>set pppoe passwd @#$goodpassword%$#
admin(network.wan)>set pppoe keepalive enable
Related Commands:
show ip
pppoe
/ Enables or disables the switch as a DHCP client.
Sets the default gateway IP address to <a.b.c.d>.
Sets the IP address of one or two DNS servers, where
<a.b.c.d>
<idx> indicates either the primary (
server, and <a.b.c.d> is the IP address of the server.
Sets up to 8 (using <idx> from
<a.b.c.d>
<a.b.c.d> for the WAN interface of the switch.
Sets the subnet mask.
/ Enables or disables the WAN interface associated with the
enable
given <idx> as set using the set ipadr command.
disable
/ Enables or disables PPPoE.
enable
disable
Sets PPPoE idle time to <val> (an integer in the range
65535
/ Enables or disables PPPoE keepalive.
Sets the PPPoE password to <passwd> (1–39 characters).
Sets PPPoE authentication to <type>, where <type> can be
one of the following values:
chap
Sets PPPoE user name to <userID> (1–47 characters).
Shows the IP settings for the WAN.
Shows the PPPoE settings for the WAN.
1
), which indicates the number of seconds.
none
.
) or secondary ( )
1 2
to ) IP addresses
8
–
1
, , , or
pap/chap pap