Setting The Trap Configuration; Setting The Trap Configuration For Snmp V1/V2C; Setting The Trap Configuration For Snmp V3 - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

7.9.3 Setting the Trap Configuration

To set the trap notification destination for SNMP, select
SNMP Trap Configuration

7.9.4 Setting the Trap Configuration for SNMP v1/v2c

To set the trap notification destination for the SNMP v1/v2c servers, add one or more entries to SNMP v1/
v2c Trap Configuration table.
1. Click the Add button to add a new entry to the table.
2. Specify a Destination IP
generated.
3. Specify a destination User Datagram Protocol (UDP) port for receiving the traps that are sent by SNMP
agents. UDP offers direct connection for sending and receiving datagrams over an IP network.
4. Specify a Community
screen.
5. Select the appropriate
server.
6. Click the Apply

7.9.5 Setting the Trap Configuration for SNMP V3

To set the trap notification destination for the SNMP v3 servers, add one or more entries to SNMP v3 Trap
Configuration table.
1. Click the Add button to add a new entry to the table.
2. Specify a Destination IP
generated.
from the left menu.
addresses for the systems that will receive notification when an SNMP trap is
name that matches one of the community names added on the SNMP Access
SNMP Version (v1 or v2)
button to save the entries.
addresses for the systems that will receive notification when an SNMP trap is
System Configuration
from the pull-down menu for this particular SNMP
7-23
Switch Administration
--> SNMP Access -->