WS2000>admin(network.wlan.rogueap)> set
Description:
Sets rogue access point parameters.
Syntax:
set muscan
apscan
detscan
fullapscan mode
Example:
admin(network.wlan.rogueap)>
admin(network.wlan.rogueap)>
Related Commands:
show
Displays the rogue AP parameters.
mode
enable
/
Enables or disables mobile unit scanning.
disable
interval
Sets the MU scan interval to <interval> (
<interval>
mode
enable
/
Enables or disables AP scanning.
disable
interval
Sets the AP scan interval to <interval> (
<interval>
mode
enable
/
Enables or disables detector AP scanning. For this feature to
disable
be fully functional, you must also set one of the Access Ports
as a detector AP. See the
command.
interval
Sets the detector AP scan interval to <interval> (
<interval>
minutes.
enable
/
Enables or disable Rogue AP detection using AP that is
disable
dedicated as a detector AP. For this feature to work, you must
set one of the APs as a Full Detector AP. See the
WS2000>admin(network.ap)> set
interval
Sets the full detector AP scan interval to <interval> (5-65535)
<interval>
seconds.
set apscan mode enable
set apscan int 60
Command Line Interface Reference
–
) minutes.
5
65535
–
) minutes.
5
65535
WS2000>admin(network.ap)> set
–
5
65535
command.
13-171
)